How do I log into the Mx000 system XSCF command line for the first time?
-
For password resets, or to configure the XSCF, you have to first log into the XSCF, using the following method:
Connect to the serial port of the XSCF
serial port log-in prompt: default
You will be prompted to toggle the keyswitch from one postion to another depending on the initial position of the keyswitch, if in locked mode, turn the key to service mode, leave for five seconds, then turn it back to locked mode, and press Enter. If in Service mode, turn the keyswitch to Locked mode, leave for five seconds, turn the keyswitch back to Service mode and then press Enter.
you should see the prompt:
XSCF>
From here you can configure the service processor and reset passwords.
© Lightnetics 2024